Motivation
Previously
BBC
Requirements
- Be powered from an independent power supply (LiPo Battery)
- Onboard charging capabilities preferred
- Interface with (ideally) 5 cameras
- For each camera
- Provide regulated power
- Be able to turn them on/off, enable video recording, and take pictures (~3 GPIO)
- Read whether the camera is on and if the camera is recording (~2 GPIO)
- Visually display the status of each camera in an obvious way
- Easily test all cameras on the launchpad (e.g. through manual test switches)
- Communicate with Pyxida over a serial bus (likely I2C)
- Use an STM32 Processor
- Programs over 5x2 50-mil pitch connector / STLink
Proposed Architecture/Block Diagram
Timeline
Development Notes
2 Comments
Luka Govedic
Also, hardware switch
Luka Govedic
And thermal sensing